Can You Refinish Prefinished Hardwood Floors

Alternatives to refinishing engineered hardwood flooring.

Can you refinish prefinished hardwood floors.

Should we keep the bevels or sand them flat. We d like hardwood in the kitchen but i don t like the beveled edges of the prefinished wood and i m not convinced we would find a perfect match of new flooring to the old. Refinishing beveled hardwood floors. If you have the solid wood type you can absolutely refinish it usually between four and seven times before the floor would need to be completely replaced.

The total bill for this project is about 100. Needless to say i told her not to use water to clean her floors but she did not listen. Uneven floors such as those with low spots can t be sanded as often because the dips cause more material to be removed in some areas. Leave the bevel in the floor and do not have the bevel filled.

Your worn down pre finished hardwood flooring can be refinished up to 5 times. Pre finished hardwoods show scratches more than site finished hardwoods. Since this is. There are steps you can take to delay the need for refinishing your engineered flooring.

Our contractor says he can sand down the prefinished floors place new hardwood in the kitchen and restain all three rooms to match. There are two types of prefinished hardwood floors. I installed bruce prefinished flooring in her home a couple of years ago. You can change the color of the entire floor each time that it s completely refinished.

Can you eliminate the bevels when you refinish pre finished floors. But since the introduction of prefinished solid hardwood during the 1940s this newer form of flooring has become increasingly popular and today you may find that it s easier to find than traditional unfinished hardwood planks. The sanding will as the name implies sand off the top layer and hence most of the bevels will be removed. My mother grew up mopping floors with pine disinfectants.

Traditionally hardwood flooring was always installed as unfinished planks that were then stained and finished with a protective surface layer right on the worksite. Solid wood which is made of actual planks of real wood and engineered wood. If the finish on your wood floor is worn and lightly scratched you can make it look like new without the labor mess and expense of sanding off the finish. Now the flooring has become grainy in texture and dull.