A circular saw and an abrasive blade would work the same.
Can you cut vinyl siding with a table saw.
If you re working on a large job you ll probably want to make end cuts with a circular saw and that s no problem as long as you use the right blade.
Mark the area to cut and slowly feed the blade into the siding.
The backward rotation of the saw blade not only cuts the vinyl but melts the edges to make a very smooth and jagged edge free cut.
This method is best for cutting a lot of short or long vertical cuts since the circular saw will create clean incisions relatively quickly.
Vinyl is easier to cut than most siding materials and you can use a number of everyday tools for the job.
But heavier and the table usually marks up the siding.
Follow these steps on how to cut vinyl siding with a pair of tin snips.
If you can dodge a wrench you can dodge a ball patches o hoolihan.
Lie a strip of vinyl siding on a flat work table.
If you re cutting dark vinyl siding run a piece of light colored masking tape over the section you want to cut.
With a pencil straightedge and measuring tape you need to draw a straight vertical line at which you want to cut the strip of vinyl siding into.
When cutting vinyl siding with a circular saw install a fine toothed blade backwards on the saw for a smoother cleaner cut especially in cold weather when the material is brittle.
Fit a circular saw with a fine toothed plywood cutting blade.
Not just any circular saw blade will do.
For the smoothest cuts put the blade in backward.
You ll need a fine tooth plywood saw blade to do this correctly.
Never tried a sliding miter saw.
You want it to be dark enough so you can see it when you re using the saw.
First lay a strip of vinyl siding onto a flat and clean working table.
But you can try it and adapt it as you like.
Go over the line a few times with the pencil.
This prevents the teeth of the saw from grabbing the material.
Using a circular saw is the first method that you can use to cut vinyl siding.
Mark the line you want to cut on the siding with a pencil and straight edge.
Make the cut slowly.
Put on safety goggles.
Black abrasive cutting blades either masonry or steel work suprisingly well to cut vinyl.
